PC Recycler

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====Using with avr-gcc==== 
              
<file asm ledon.S>
;;;;   assemble with:-    avr-gcc -c ledon.S 
;;;;   the output file produced is ledon.o
;;;;   use:- avr-objcopy -O ihex ledon.o ledon.hex to get intel hex file
;;;;   upload this file to the arduino using avrdude:-
;;;;   avrdude -p m328p -c Arduino -P /dev/ttyACM0 -b 115200  -Uflash:w:ledon.hex:i -v -v

; Load the binary pattern 11111111 into Register 16	              
LDI    R16,  0b11111111 

; send all the 1s to the Data direction register at address 0x04
; to configures all lines on Portb  as an Outputs      
OUT    0x04, R16              


; not really needed, already loaded wits 1s.
;but later if we put all zeros here the LED would go off 
LDI    R16,  0b11111111


; Send all the 1s to all lines on port B at address 0x05. 
;A 1 takes the line up to 5 volts and lights the LED
;A 0 takes the line down to 0 volts and the LED goes off.     
OUT    0x05, R16             

; If we had an LED connected to each line of port b, they would all light up.
 
             
stop:
rjmp stop                    ;don't run on past end of program 
                
</file>

PC Recycler

User Tools

Site Tools

Page Tools